What are the options for adding ADSB-in to the following panel? The 430 and Aspen should both be capable of showing traffic and weather, if properly integrated with something....
Aspen 1000 Pro Max
Garmin GNS-430W
GARMIN GTX-330ES
I also have an Aspen but with a GNS430W. I was, in the distant past, very hot to get the ADSB weather and traffic on the panel somehow, I never did. But I do get the output from my Stormscope WX500 to both the Aspen and 430W, which is very nice.
In my research, there were various ADSB transceivers out there at the time that interfaced with the Aspen after key turn on, one of which being the NGT9000. There was also an Aspen ATX 200, which was IIRC a rebranded Freeflight Rangr XVR. I think the Freeflight was able to interface traffic with the GNS430W, as was the I’ll fated Navworx ads600-B. I think I remember that the KT74 could also show traffic on the 430W, but that might have been only TIS-A.
However, since I wanted to keep using FLYQ, this prevented me from considering the various Garmin ADSB solutions, like the 345, that enabled panel display.
As I waited to the very end of mandatory ADSB out for controlled airspace, I went the cheap route with TailBeacon and continuing to use my KT76A. While definitely not a panel mount situation, I simulated this by coupling with my portable Stratux receiver and wifi’d the weather and traffic to my 10.5 inch IPad, and have the traffic also show up on my IPhone simultaneously using a ram mount on the windshield. So while I only really needed the traffic always visible on the IPhone as an alerter in my scan, I could refer to the IPad for fine detail for both traffic and weather.