During my second solo (touch-and-goes at an uncontrolled airport with a right-hand traffic pattern), the pattern started getting pretty congested. I was flying a Cessna 150, and was joined by other trainers, a couple of twins and one gulfstream jet. My question is: What tools are at a pilots disposal to maintain separation from other aircraft flying different speeds at an uncontrolled airport?
A couple specific questions from that flight:
*When the Gulfstream called ten mile final and I had just taken off for a touch-and-go, I climbed to pattern altitude, extended upwind, and turned x-wind later than usual to give him time to land (no other planes in the pattern at that time). I also flew a wider downwind leg. Are either of these (extending upwind, widening downwind) correct? I'd heard of extending downwind, but not extending upwind or making a wider downwind leg. In this situation, I thought it would be safer to stay on the side of the airfield away from the landing Gulfstream than potentially crossing paths on my downwind/his final. Thoughts?
*That same flight there was a Cessna Skylane ahead of me in the pattern, also doing touch-and-goes. He was on final for a touch-and-go when I was behind him on the downwind leg. I extended downwind to give him time to land, but didn't extend enough and on turning final he was still on the runway. He did take off in time for me to safely land behind him.
My question is: if he was still on the runway, and I wasn't able to land, what would have been the best course of action to take? I think I would have performed a go-around, keeping left of the runway (right-hand traffic pattern), but not sure what I would have done next given that he was taking off again and would stay in the pattern. What are some options to get back into the pattern and stay out of his way in that situation?
Any other tools to buy more time? What about 360 turns from/to downwind leg? How would the radio call for that go?
Any thoughts or advice are appreciated!
Tracklog from the flight:
http://tinyurl.com/kvugsaf
A couple specific questions from that flight:
*When the Gulfstream called ten mile final and I had just taken off for a touch-and-go, I climbed to pattern altitude, extended upwind, and turned x-wind later than usual to give him time to land (no other planes in the pattern at that time). I also flew a wider downwind leg. Are either of these (extending upwind, widening downwind) correct? I'd heard of extending downwind, but not extending upwind or making a wider downwind leg. In this situation, I thought it would be safer to stay on the side of the airfield away from the landing Gulfstream than potentially crossing paths on my downwind/his final. Thoughts?
*That same flight there was a Cessna Skylane ahead of me in the pattern, also doing touch-and-goes. He was on final for a touch-and-go when I was behind him on the downwind leg. I extended downwind to give him time to land, but didn't extend enough and on turning final he was still on the runway. He did take off in time for me to safely land behind him.
My question is: if he was still on the runway, and I wasn't able to land, what would have been the best course of action to take? I think I would have performed a go-around, keeping left of the runway (right-hand traffic pattern), but not sure what I would have done next given that he was taking off again and would stay in the pattern. What are some options to get back into the pattern and stay out of his way in that situation?
Any other tools to buy more time? What about 360 turns from/to downwind leg? How would the radio call for that go?
Any thoughts or advice are appreciated!
Tracklog from the flight:
http://tinyurl.com/kvugsaf