I recently installed LED nav lights. The right side has been intermittent lately. Bright, then dim, then barely seen. Only returns to full brightness when I remove and put back in with a little force. Possible bad ground/contacts needs cleaning? Silly question, but what is a good way to do this? A certain product to use that is safe for conductivity? It was an issue on the previous Grimes light, too. Thanks.
Intermittent Nav Light - simple question
- Thread starter Chilito
- Start date
smv
Pattern Altitude
- Joined
- Dec 30, 2019
- Messages
- 1,661
- Display Name
Display name:
smv
kshaw
Pre-takeoff checklist
I use ACF-50 on bulb contact points with some maroon scotchguard. If your Cessna is like my Warrior, you will have a ground strap going from the bulb to the the wing. Mine has failed four times. Repair requires removal of the wing tip and and a new strap or a short strip of wire. A volt/ohm meter can tell you if the problem is on the power side or the ground.
Not enough info. Are you saying that you replaced incandescent bulbs with LED bulbs in the original nav light receptacle?
Ghery
Touchdown! Greaser!
- Joined
- Feb 25, 2005
- Messages
- 10,945
- Location
- Olympia, Washington
- Display Name
Display name:
Ghery Pettit
weirdjim
Ejection Handle Pulled
- Joined
- Jul 8, 2008
- Messages
- 4,171
- Location
- Grass Valley, CA (KGOO)
- Display Name
Display name:
weirdjim
I didn't know that Lucas made lights for US registered GA.
Oh, yes, they absolutely do. They even deliver them with the standard Lucas switch plate: "Dim, Flicker, Off".
Jim