I'm just learning about IFR approaches and was wondering how I would fly the LOC RWY 30C approach at KIWA (Phoenix Mesa Gateway).
The chart has the ILS and LOC approach on the same plate. I'm looking at the version from skyvector.com (it's also attached to this post).
The top-left lists the "LOC I-IWA" navaid with a single underlined frequency. It doesn't have a channel number, so I'm assuming that it doesn't have DME. I also confirmed this in X-Plane 11 in the sim. On the chart, I also see "IWA" (as opposed to I-IWA) in the top-down view, which is a VOR, and it has DME (it says Chan 80 below the morse code identifiers).
SNOWL INT is listed with (IAF) - initial approach fix.
On the vertical profile of the SID, SNOWL is listed as being 6.4 DME from IWA (not I-IWA).
If I were to fly this approach, would I put in I-IWA (110.15) in my NAV1 radio and get the LOC signal? If yes, how would I know when I was 6.4 DME away from IWA (not I-IWA) at SNOWL to start the approach?
The chart has the ILS and LOC approach on the same plate. I'm looking at the version from skyvector.com (it's also attached to this post).
The top-left lists the "LOC I-IWA" navaid with a single underlined frequency. It doesn't have a channel number, so I'm assuming that it doesn't have DME. I also confirmed this in X-Plane 11 in the sim. On the chart, I also see "IWA" (as opposed to I-IWA) in the top-down view, which is a VOR, and it has DME (it says Chan 80 below the morse code identifiers).
SNOWL INT is listed with (IAF) - initial approach fix.
On the vertical profile of the SID, SNOWL is listed as being 6.4 DME from IWA (not I-IWA).
If I were to fly this approach, would I put in I-IWA (110.15) in my NAV1 radio and get the LOC signal? If yes, how would I know when I was 6.4 DME away from IWA (not I-IWA) at SNOWL to start the approach?