southallb
Pre-Flight
- Joined
- Jan 2, 2018
- Messages
- 48
- Display Name
Display name:
southallb
Wanting to get my commercial rating and CFI, been doing some research and need some clarification on time requirements.
Currently have PPL and Instrument ratings with ~150 hours
Part 141 - Commercial Pilot Certification Course
35 hours of ground instruction
flight training
120 hours of training if the course is for an airplane or powered-lift rating
?? Does my PPL and Instrument training time count toward this 120 hours ??
For an airplane single-engine course:
55 hours of flight training from a certificated flight instructor on the approved areas of operation listed in paragraph (d)(1) of this section that includes at least -
(i) 10 hours of instrument training using a view-limiting device including attitude instrument flying, partial panel skills, recovery from unusual flight attitudes, and intercepting and tracking navigational systems. 5 hours of the 10 hours required on instrument training must be in a single engine airplane;
?? Does my instrument training fulfill this requirement ??
(ii) 10 hours of training in an airplane that has a retractable landing gear, flaps, and a controllable pitch propeller, or is turbine-powered;
(iii) One 2-hour cross country flight in daytime conditions in a single engine airplane that consists of a total straight-line distance of more than 100 nautical miles from the original point of departure;
?? Does my instrument x-cntry fulfill this requirement ??
(iv) One 2-hour cross country flight in nighttime conditions in a single engine airplane that consists of a total straight-line distance of more than 100 nautical miles from the original point of departure; and
(v) 3 hours in a single-engine airplane in preparation for the practical test within 60 days preceding the date of the test.
Solo training.
(a)For an airplane single engine course. Ten hours of solo flight time in a single engine airplane, or 10 hours of flight time while performing the duties of pilot in command in a single engine airplane with an authorized instructor on board. The training must consist of the approved areas of operation under paragraph (d)(1) of section 4 of this appendix, and include -
(1) One cross-country flight, if the training is being performed in the State of Hawaii, with landings at a minimum of three points, and one of the segments consisting of a straight-line distance of at least 150 nautical miles;
(2) One cross-country flight, if the training is being performed in a State other than Hawaii, with landings at a minimum of three points, and one segment of the flight consisting of a straight-line distance of at least 250 nautical miles; and
(3) 5 hours in night VFR conditions with 10 takeoffs and 10 landings (with each landing involving a flight with a traffic pattern) at an airport with an operating control tower.
Thanks
Currently have PPL and Instrument ratings with ~150 hours
Part 141 - Commercial Pilot Certification Course
35 hours of ground instruction
flight training
120 hours of training if the course is for an airplane or powered-lift rating
?? Does my PPL and Instrument training time count toward this 120 hours ??
For an airplane single-engine course:
55 hours of flight training from a certificated flight instructor on the approved areas of operation listed in paragraph (d)(1) of this section that includes at least -
(i) 10 hours of instrument training using a view-limiting device including attitude instrument flying, partial panel skills, recovery from unusual flight attitudes, and intercepting and tracking navigational systems. 5 hours of the 10 hours required on instrument training must be in a single engine airplane;
?? Does my instrument training fulfill this requirement ??
(ii) 10 hours of training in an airplane that has a retractable landing gear, flaps, and a controllable pitch propeller, or is turbine-powered;
(iii) One 2-hour cross country flight in daytime conditions in a single engine airplane that consists of a total straight-line distance of more than 100 nautical miles from the original point of departure;
?? Does my instrument x-cntry fulfill this requirement ??
(iv) One 2-hour cross country flight in nighttime conditions in a single engine airplane that consists of a total straight-line distance of more than 100 nautical miles from the original point of departure; and
(v) 3 hours in a single-engine airplane in preparation for the practical test within 60 days preceding the date of the test.
Solo training.
(a)For an airplane single engine course. Ten hours of solo flight time in a single engine airplane, or 10 hours of flight time while performing the duties of pilot in command in a single engine airplane with an authorized instructor on board. The training must consist of the approved areas of operation under paragraph (d)(1) of section 4 of this appendix, and include -
(1) One cross-country flight, if the training is being performed in the State of Hawaii, with landings at a minimum of three points, and one of the segments consisting of a straight-line distance of at least 150 nautical miles;
(2) One cross-country flight, if the training is being performed in a State other than Hawaii, with landings at a minimum of three points, and one segment of the flight consisting of a straight-line distance of at least 250 nautical miles; and
(3) 5 hours in night VFR conditions with 10 takeoffs and 10 landings (with each landing involving a flight with a traffic pattern) at an airport with an operating control tower.
Thanks