timwinters
Ejection Handle Pulled
I went flying this today, for the first time in two weeks & had an iteresting discovery during preflight that I thought was worth sharing.
Conditions:
The plane is kept in an unisulated hangar w/ roof and walls, but no doors.
Temps here over the last few days:
Today........................Yesterday.........................Friday
Low 18, High 45...........Low 23, High 35.................Low 24, High 40
I'm finishing up the preflight and hop up on the ladder to confirm the fuel levels and...holy ****. Look at that!
From wingtip to wingtip there is a line of ice and it's up to 8" wide and 1/2" deep in the middle. Woaaaahhhh.
We all know how the underside of an uninsulated steel roof on a hangar (or barn) likes to sweat in the mornings as the temps rise. Well, in my case, a purlin is centered right over my wing for the full length and since the moisture tends to drip at the purlins, it drips on my wing. Apparently, the plane's skin stayed below freezing over the last few days and, as the building was taking its morning sweat, the water froze in a line the full length of the wing.
This discovery was made about 10:30 am and the temp was already 38* so I pulled the plane out into the sun and let it warm until the sun started the ice melt process (confirming the plane's skin was above freezing) and then hosed it off. The ice melted away, and I let the plane sit until it was essentially dry.
Then I had a great flight!
Interesting find and one I hadn't run across before.
Be careful out there.
Conditions:
The plane is kept in an unisulated hangar w/ roof and walls, but no doors.
Temps here over the last few days:
Today........................Yesterday.........................Friday
Low 18, High 45...........Low 23, High 35.................Low 24, High 40
I'm finishing up the preflight and hop up on the ladder to confirm the fuel levels and...holy ****. Look at that!
From wingtip to wingtip there is a line of ice and it's up to 8" wide and 1/2" deep in the middle. Woaaaahhhh.
We all know how the underside of an uninsulated steel roof on a hangar (or barn) likes to sweat in the mornings as the temps rise. Well, in my case, a purlin is centered right over my wing for the full length and since the moisture tends to drip at the purlins, it drips on my wing. Apparently, the plane's skin stayed below freezing over the last few days and, as the building was taking its morning sweat, the water froze in a line the full length of the wing.
This discovery was made about 10:30 am and the temp was already 38* so I pulled the plane out into the sun and let it warm until the sun started the ice melt process (confirming the plane's skin was above freezing) and then hosed it off. The ice melted away, and I let the plane sit until it was essentially dry.
Then I had a great flight!
Interesting find and one I hadn't run across before.
Be careful out there.