Badger
Pattern Altitude
- Joined
- Dec 29, 2011
- Messages
- 2,136
- Display Name
Display name:
Badger
I have read/interpretated (yes I searched here)
http://rgl.faa.gov/Regulatory_and_Guidance_Library/rgFar.nsf/FARSBySectLookup/61.109
The verbiage is a little confusing in sentence 5, sub (ii) (see below)
(5) 10 hours of solo flight time in a single-engine airplane, consisting of at least--
(i) 5 hours of solo cross-country time;
(ii) One solo cross country flight of 150 nautical miles total distance, with full-stop landings at three points, and one segment of the flight consisting of a straight-line distance of more than 50 nautical miles between the takeoff and landing locations; and
(iii) Three takeoffs and three landings to a full stop (with each landing involving a flight in the traffic pattern) at an airport with an operating control tower.
Specifically the word "and" at the end of this requirement followed by the section (iii) that requires 3 from operating control tower. Maybe I'm reading into this too much. In short: is section (iii) requirements incorporated within section (ii) or are they independent requirements?
http://rgl.faa.gov/Regulatory_and_Guidance_Library/rgFar.nsf/FARSBySectLookup/61.109
The verbiage is a little confusing in sentence 5, sub (ii) (see below)
(5) 10 hours of solo flight time in a single-engine airplane, consisting of at least--
(i) 5 hours of solo cross-country time;
(ii) One solo cross country flight of 150 nautical miles total distance, with full-stop landings at three points, and one segment of the flight consisting of a straight-line distance of more than 50 nautical miles between the takeoff and landing locations; and
(iii) Three takeoffs and three landings to a full stop (with each landing involving a flight in the traffic pattern) at an airport with an operating control tower.
Specifically the word "and" at the end of this requirement followed by the section (iii) that requires 3 from operating control tower. Maybe I'm reading into this too much. In short: is section (iii) requirements incorporated within section (ii) or are they independent requirements?