You better check if SCAT is the correct material. Otherwise you may end up reading your name in a NTSB docket
https://data.ntsb.gov/carol-repgen/api/Aviation/ReportMain/GenerateNewestReport/88439/pdf
Yes provided you dont need to disassemble anything of importance like remove the carb to replace the hose. The listing in 43 App A(c) are considered "catagories" similar to the major alteration, etc listings in the same appendix. So long as you can fit the task into one of those categories and it falls within the definition of preventative maintenance you are okay. But keep in mind you are held to the same criteria as an A&P when performing preventative maintence so be sure to use the proper replacement parts and make an entry for the work per 43.9.Does this include replacing SCAT tubes and the duct between the air cleaner and carburetor?
If you are replacing the SCAT hoses from air cleaner to carburetor on a Piper, see the Service Bulletin which requires using the Piper part. The Service Bulletin came out because some of the non-Piper hoses collapsed during takeoff causing some accidents.In Part 43, appendix A, subpart C, owners are allowed to replace any hose connection except hydraulic connections. Does this include replacing SCAT tubes and the duct between the air cleaner and carburetor?
If you are replacing the SCAT hoses from air cleaner to carburetor on a Piper, see the Service Bulletin which requires using the Piper part. The Service Bulletin came out because some of the non-Piper hoses collapsed during takeoff causing some accidents.
If you are replacing the SCAT hoses from air cleaner to carburetor on a Piper, see the Service Bulletin which requires using the Piper part. The Service Bulletin came out because some of the non-Piper hoses collapsed during takeoff causing some accidents.
I think part 43 says "hose connection." Nothing about replacing the hose itself or ducting.In Part 43, appendix A, subpart C, owners are allowed to replace any hose connection except hydraulic connections. Does this include replacing SCAT tubes and the duct between the air cleaner and carburetor?
I think part 43 says "hose connection." Nothing about replacing the hose itself or ducting.
The first sentence in para (c) says: Preventive maintenance is limited to the following work.Appendix A is to be considered a set of examples, not an all-inclusive list.
The first sentence in para (c) says: Preventive maintenance is limited to the following work.
Permitted work tasks are subsequently listed. If other tasks were allowed it would say not limited to the following
Yes, it does say that. But FAA legal subsequently published a more liberal interpretation. See https://www.faa.gov/about/office_org/headquarters_offices/agc/practice_areas/regulations/interpretations/Data/interps/2009/Coleal-Bombardier Learjet_2009_Legal_Interpretation.pdf .
“As with the other paragraphs of Appendix A (i.e., on major repairs and major alterations), the lists are better viewed as examples of the tasks in each category-they cannot be considered all- inclusive. There are, no doubt, many "simple or minor preservation operations [tasks]" and many "replacement of small standard parts not involving complex assembly operations" performed daily, especially on small general aviation aircraft, that the agency would consider to be preventive maintenance, though they are not included in the 32 listed items.“
I think part 43 says "hose connection." Nothing about replacing the hose itself or ducting.
This and the similar limitation stated in the associated AC had been dealt with through other guidance until the Coleal LOI issuance made it easier. While this LOI is specific to a transport type aircraft it did provide a similar path found with the guidance involving the major alterations and repairs listings in the same 43 appendix.The first sentence in para (c) says: Preventive maintenance is limited to the following work.
If this forum only had a search function...................
If you are replacing the SCAT hoses from air cleaner to carburetor on a Piper, see the Service Bulletin which requires using the Piper part. The Service Bulletin came out because some of the non-Piper hoses collapsed during takeoff causing some accidents.
You are so wrong I actually feel bad calling you out.The first sentence in para (c) says: Preventive maintenance is limited to the following work.
Permitted work tasks are subsequently listed. If other tasks were allowed it would say not limited to the following
This is the most useful post I have seen on PoA.
This☝. I do a lot of maintenance work on my plane but I discuss everything with my A&P and anything that would not fall under owner maintenance (or a reasonable Coleal interpretation) I have him sign off on it. He’s the one signing off on the next annual anyway so he has to be confident everything is done properly. But I have all of the manuals, research everything to the nth degree before starting, and ask lots of questions. Probably takes me 10x as long to do it, and likely even more $. But I learn in the process, have confidence that my plane is maintained to my standards. And my way too busy A&P appreciates my plane not taking up a semi permanent parking spot in his hangar.Having a working relationship with an A&P/IA, especially the one who does your annuals, is a great insurance policy for owner maintenance. First, whenever you are unsure of what you can do and how to do it, you can have a quick chat with your A&P to clarify. Second, if you do wind up getting into something you shouldn't, the A&P can supervise you or do a conformance inspection and log the work.
What is that service bulletin number? Couldn't find one. Also which aircraft, all Pipers? Thanks Bob
How long do I have to wait for the explanation? I'm not a young fella you know . . .You are so wrong I actually feel bad calling you out.
I will enjoy jumping on this dog pile. Enjoy!