Search results

Hmm...went looking for it and could not find it. Weird, Piper usually sends me an email with them. EDIT: Nevermind, found it. Interesting it was just for the PA28 line, not the 32 or 34 which also have the friction lock like that.

Trying to chase this exact issue down right now on one cylinder on each engine. Last remaining issues I've been seeing. Loving them on the Seneca now Dave! Buyer loves it on the Lance we sold him as well!!

When it's time to overhaul my NSD-360, it'll get replaced with a G5. Hopefully by then the AI will be compatible with my Century III lol

Didn't "replace" any hoses per se. Modified the oil pressure hard lines to work with the new sensors. Pretty much the same for the manifold pressure lines. I did have to buy about 10 feet of Aeroquip 303, fire sleeve, bands, and fittings to make extensions for my fuel lines in order to...

To the contrary. I do gain back weight, but I look at it as my gauges were in a place that didn't matter anyhow. I already have the start of a second "6 pack" on the co-pilot side which was a glovebox before. Not sure if I miss the glovebox or like the second set of instruments. I put the...

You are correct! That's actually the last little thing that I'm working on at the moment. We did hook the harness wires up for the AMP reading to the existing Ammeter shunts, but it's requiring a little fine tuning. We'll touch on that later ;)

So wow, it’s really been awhile since I’ve been able to get back in and update this thread. The installation is completed, and now it’s time to go back and chronicle how we did it. When we last left off, we showed you the steps taken to actually order the Electronics International CGR-30P...

After living in Las Vegas for 3 years, no other casino really compares, but I know what you mean. We are both non-smokers, so walking into the place was fairly difficult, I won't lie. They do have a non-smoking section, but you have to walk through the rest of the casino to get there. I am...

Oops...oh well. After about 2 hours with the service manual and 30 minutes on the phone with Hartzell Aircraft Tech., I determined it was the air pressure switch. Ordered a new one, replaced it (as per HET's instructions), and it works fine now. It was very obvious what was wrong when I...

I seem to be able to reliably get my B3040 heater to function on the ground, but once I climb into the air, the hot air stops coming. Anyone else have an issue and give me a place I might start? I can verify power is going to the unit and that the blower works (on the ground and in the air). As...

The wife and I had the opportunity to visit this very nice resort a couple weeks back. If you're in the area, I highly recommend checking it out. Two beautiful resorts, three golf courses, plenty of good food, spas, and they will come pick you up at the airport in a shuttle bus for free! They...

*SOLD*

LOL, I couldn't find my pencil so I had to use my favorite pen!

I did before listing...selected somewhere in the middle. No need for it and I don't need it cluttering my hangar...so if someone now would like to make an offer, I would be receptive. Thanks!

Accepting offers...last thing I still have from the panel that came out.

*SOLD*

*SOLD*

Would you split off one VSI?

*SOLD*

*SOLD*