PilotRPI's latest activity

Anyone have experience with Air Tech Coatings for a fabric system? Especially regarding longevity? Sounds some info on the supercub...

Phillips is approved for break in. I've had some A&P's recommend it for break in.

Thank you. I'll be doing a borescope as part of a prebuy.

Shouldn't be a problem. Most people use mineral oil to assist with the break-in, but Phillips multi-weight shouldn't be a problem, as...

For this one they had all new bearings, seals, honed cylinders, piston rings, so probably closer to an overhaul. I'll be doing a...

I'm looking at buying a plane, O-320, but I think they broke in their engine after an IRAN with Philips multi weight rather than...

Any suggestions for brokers? I figured Avemco is worst case cost wise, so if I can stomach that I'll hopefully end up a little better.

The rates you have that don't seem to far off from Avemco. Other taildraggers (Citabrias, PA12) we're about $2k for similar hull.

I'm still on the hunt for a plane and was considering a Maule taildragger. I called Avemco for a quote and it was almost $6k. I have...

Couple weeks ago I tested positive, taught the entire week online (Teams) and the two times I went to the store, wore a mask both for my...

Had a 300D in my 172B. Was a great engine if you weren't looking for a rocket ship. I would keep running it and do an oil analysis at...

As mentioned use time in between to start knocking out the cross country hours. If you have time and want to start studying for the ifr...

Poop BEFORE you go, don't try to hold it.

St Augustine or a short hop from Jacksonville would work too

I was wondering if anyone has a mechanic in the Jacksonville area they would suggest for a prebuy. It is a Citabria, so hopefully...