Magman's latest activity

There was a time when every airport had a mechanic or two that did Engines, structures, mags, carbs etc. These folks were referred to...

Nope. Just a rumor. I’ve done minor things for many years. Always tried to minimize involvement with “D’s” but hasn’t always...

“Coming-in Speed” is the Minimum MAGNETO RPM that will produce a consistent spark. For a Bendix/Continental mag this is 150 Magneto...

What type is this? Could it be that an ELT was defective last year and was replaced a then “Serviceable” unit that is now defective...

The impulse doesn't have magnets. The magneto has the magnet, and the impulse simply stops the mag's rotation while the coupling...

Like many forums; there does not seem to be a shortage of folks asking for advice. However; they often leave out the important...

“ Not provide a spark under cranking speed” is a comment I fail to understand. How was this determined? No start or cowl off? You...

The Impulse Coupling can disintegrate and wreck the engine. If you hear clicking this is not likely. 2 things that can cause this: 1...

IIRC AC43.13-2B has data for anti-collision light installations. Coverage is measured in “steradians” which are square degrees. It...

fwiw department. Had coke bottle thick lenses most of my life. Wouldn't even get up to pee in the middle of the night without putting...

Not in my view or experience. Each system is independent and while one system can influence other systems the goal is to fix the broken...

I have an OLD textbook that shows some type of split sleeve reinforcement using CLAMPS. I don’t recall the application or conditions...

Often overlooked is the importance of assuring that the Equipment List reflects the actual configuration of the aircraft at time of...

I agree with the comments of Dan and Bell. Recently met a Tripacer where conical mounts had compressed and allowed the Engine to sag...

Mounts should be replaced, not rotated. Their rubber gets hardened and sometimes cracked. I have found mounts sagging so badly that the...