FORANE's latest activity

I have a 37 ton log splitter from Northern Tool that had a nylon 2 inch connector to the reservoir. Its threads melted leaking hot...

Apart from a well controlled study comparing the 2 oils, we're unlikely to have a definitive answer about which one if either is best...

I would ask that shop if they would rebuild that engine again, for free, if it did not break in properly and had high oil consumption...

If you had an engine overhauled by a shop that specified Phillips xc20w50 be used, would you use it or the opinion of Lycoming?

If you had an engine overhauled by a shop that specified Phillips xc20w50 be used, would you use it or the opinion of Lycoming?

Phillips is approved for break in. I've had some A&P's recommend it for break in.

The water is hard, but not particularly corrosive. Obviously the water seems to be attacking the tanks. I suppose there could also be...

Yeah, many or possibly most manufactures have gone cheap. Plastic drain valves are a good example of this. During installation those...

Normal Tankless have their place, but if you want reliable hot water the old fashioned tanked water heaters are best.

Are you planning on sending them to puppy school and taking out loans?

Whenever I have measured it's to the bottom of the tread. Maybe some manufacturers measure differently?

The ones we've bought a couple sets of were for car and van use. They were the FALKEN 255/55R18 109V XL ZIEX CT60 A/S BW...

Excuse me Mr eman sir, Are sweet potato fries allowed to be discussed here? Technically they qualify per the rules, I think.

Pick a day with smooth air so you aren't limited by maneuvering speed when you're at full throttle below 7,000 msl maximum.