buzzard86

Good questions. Yokes are in good shape but chipping on grips (not pictured). I didn't think powder coating got concerningly hot, but I...

Ok guys, new question. I’d like to get these powder coated while they’re off. Before I do anything that could damage the center logos...

Indeed! The wealth of information here and the generosity of people sharing their expertise is amazing.

Thanks! I didn't even think of a plug... was figuring I'd have to replace the whole cover.

"Switching to guns..." :p

I may have to. Just saw the replacement from Piper is $250!

Success! A&P said one came out easily and the other was a PITA. They are in good shape and I got the u-joints with them. Question, the...

Poor choice of words on my part!

Hey guys, thanks to ALL for the great info in this thread. Will definitely revisit this content with my A&P for the reinstall. The...

Dan, this schematic is a HUGE help. Is #30 the pin in question, or better to pull #24 and the entire u-joint? And if I'm understanding...

My mechanic is away and these will likely be scooped up by someone else if I hesitate, thus my post here. They're reasonably local, I...

I have no idea. I'm hoping that I can remove more than I need and then have my A&P sort it out.

Yeah, I have the 1.125 inch shaft in my ‘70 Cherokee 140, which I think is the same as the warrior

I have a message in, but he’s out of country so I don’t expect to hear back for a few days. I assumed that this was a simple swap since...

Dang. Great info, thanks. I’ve obviously never done it before. Pulling a set of rams horns from a parts plane to have installed to...